COMPLEX RADIO CONTROL SYSTEM
and transmitter at a height of at least 80cm (3ft) from the ground. A
properly operating transmitter and receiver should reliably control
the model at a distance of at least 50 meters (or 50 yards) in the test
mode. If this is not the case, be sure to check the correct installation
of the receiver antennas. If the test is not successful afterwards then
do not use the device and contact your dealer or one of our service
centers.
ź Alternatively, you can run the range test in the DC/DS transmitter
via the System – Servo & Range Test menu.
Setting into Range Test mode:
ź Connect the binding plug into the Ext. port of the receiver, turn on
the receiver and then the transmitter. Range test mode will be
active for as long as the bind plug is inserted in the Ext. port.
During the range test, the transmitter warns with an acoustic
signal that it is reduced transmission power.
By range testing, you verify the correct operation of the transmitter
and receiver. You should perform a range test before your first flight
of each flight day, or if there are any doubts about the function of
the transmitter or receiver. In the range test mode, the transmit
power is reduced to 10%. When testing range, place both the model
3.5. Range test
You may bind an arbitrary number of receivers to one transmitter.
The receiver, however, can only be bound to one transmitter, i. e. the
receiver is only bound to the most recently bound transmitter.
EN
9
To Next Page
