COMPLEX RADIO CONTROL SYSTEM
ź Up to 16 stabilised airplane channels.
ź Support for different multicopter types – from tricopters to
octocopters.
ź Up to 3 adjustable flight modes, options for stabilising the
horizon and altitude.
2.1. Properties
ź Available telemetry: Receiver voltage, signal quality, G-force,
attitude orientation.
ź Full set-up options with DC/DS transmitters or via PC.
ź Support of telemetry and up to 3 sensors connected directly.
ź Vibration analysis.
ź Always check the polarity of the lead wires so that the voltages on
the receiver and other electronics are not reversed.
ź Do not expose the receiver to heat and sudden temperature
changes that may affect the accuracy of the sensors.
ź Support for LED strip consisting of WS2812 chips.
ź Intelligent fail-safe.
ź Using the latest 3-axis gyroscope and 3-axis accelerometer.
ź Support for external camera gimbal driven by servos.
ź In-flight gain tuning using free channels.
2.2 Important Notices
ź Always use the current firmware in your DC/DS transmitter and
receiver. The minimum version of software for transmitters
supporting REX A receivers is 4.24.
ź When installing on a combustion engine model, keep in mind
ź Never use a receiver that is visibly damaged. In particular, check
the state of the antennas regularly. In no way modify or remove
the receiver electronics from the supplied housing.
EN
3
To Next Page
Loading...
