COMPLEX RADIO CONTROL SYSTEM
Gain tuning channels - Ailerons/Roll, Elevator/Pitch and
Rudder/Yaw - assign proportional channels controlling
stabilisation gains in each axis if needed. Positive value increase up
to double the default gain, while negative percent values decrease
to a minimum of 10%. The value of 0% corresponds to the
unchanged default gain value.
5.3. Camera gimbal
REX A receivers support the connecti-
on of up to three-axis camera gimbal,
whose individual axis (roll, tilt and pan)
are controlled by servos connected to
individual channels. If you plan to use
this feature, activate it in the Assist
Setup Wizard, click "Use gimbal". You
Fail-Safe channel - Here you can assign a dedicated channel
operated by a two-position switch that, after switching to the active
position, will simulate the signal loss event. The servos will move to
their predefined positions afterwards. Engine control remains
active.
Assist-Off channel - Here you can assign a dedicated channel
operated by a two-position switch, which, when switched to the
active position, forces the stabilisation to switch off (i.e. the airplane
model will enter the manual control mode while the multicopter
stops the motors immediately).
Note: multicopters may stop motors immediately after activation.
EN
31
To Next Page
Loading...
