COMPLEX RADIO CONTROL SYSTEM
9.3. Multicopter models
In the „Configuration/Multicopter Settings” menu, be sure to pay
attention to the Minimum running throttle parameter. Increase
Please make sure that the stabilisation gain tuning function has
been created on the transmitter and has been assigned to a free
channel (8-24). Stabilisation gain control knob, or a three-way
stabilisation flight mode switch (Off/Normal/Heading Hold)
should be added in the „Model/Functions Assignment” menu in
your DC/DS transmitter. Subsequently select this function for a
free channel in the „Model/Servo Assignment” menu. Now it is
possible to start the Quick Wizard in the receiver menu, where in
step 6 this three-position switch can be used.
5. Stabilisation gain tuning channel for ailerons, or other axis,
cannot be assigned.
1. The transmitter announces "Armed", but the motors are not
spinning.
4. When the stabilisation is enabled, the control surfaces do not
return to the center position even when the model is at rest
for a longer time.
In Heading Hold mode, the model remembers its original
direction before displacement and tries to return to that
position. Therefore, control surfaces may be out of neutral even
when the model is at rest. Switch stabilisation to another mode
(e.g. Normal or Manual).
flight and land. Now reassign the primary channels
„Configuration/Channel Assignment” menu.
EN
49
To Next Page
