COMPLEX RADIO CONTROL SYSTEM
5.2. Additional channels
To assign additional channels, locate
„ C o n f i g u r a t i o n / C h a n n e l
As si gnm en t/ Ass ig n Ad di ti on a l
Channels”. For proper operation, each
channel must first be created on the
transmitter – when using DC/DS
t r a n s m i t t e r v i a t h e „ M o d e l
menu/Function Assignment” and
„Servo Assignment”.
Flight mode switching channel - here
you can assign a dedicated channel to
switch flight modes. This channel
should ideally be operated by a three-
way switch on the transmitter.
2. In the transmitter menu "Menu/Model/Servo assignment"
assign the created functions to the receiver outputs. Use
unnecessary and unused outputs.
Throttle channel - is important for
multicopter models. A proportional
throttle control channel will be shown
here.
1 . I n t h e t r a n s m i t t e r m e n u
" M e n u / M o d e l / F u n c t i o n
assignment" create the necessary
functions and assign controls to
them. In the picture, these are the
functions "Gain" for setting the sensitivity of stabilisation and
"Mode" for switching flight modes of stabilisation.
EN
30
To Next Page
Loading...
