COMPLEX RADIO CONTROL SYSTEM
Number of PPM channels – setting the number of channels for
PPM output.
Direct - all receiver settings (e.g. Fail-Safe) are not included in
serial communication
Output period – setting the signal period for the servos. At lower
values, the servos have a faster response and more consumption.
For analog servos, the recommended period is 20ms, for digital
servos "Auto".
PPM/UDI (S.BUS) mode - defines how the transmitter data is
processed. You can choose from the following modes:
Low Voltage Alarm - used to set the decision level of the low
voltage alarm, which is indicated by the receiver itself. You can also
set the low voltage alarm directly in the DC/DS transmitter „Timers /
Sensors/Alarms” menu).
Computed - all receiver settings (e.g. Fail-Safe) are part of serial
communication
Note: this option does not apply to „EX Bus” outputs. These are
always direct without receiver recalculation (if the function
"Stabilise EX Bus output" is not activated).
Stabilise EX Bus output - by confirming this option, you activate
flight stabilisation Assist in the EX Bus serial communication
output. This mode is required if you use the REX Assist receiver with
active stabilisation as a satellite receiver connected to the Central
Box.
EN
38
6 Advanced properties
To Next Page
Loading...
