COMPLEX RADIO CONTROL SYSTEM
6.4. Arming switch
The arming procedure is automatic for
a i r p l a n e m o d e l s s o t h a t t h e
stabilisation is enabled automatically
after receiver initialisation. On the
contrary, for multicopters, you must
move the controls to the extreme
positions when the throttle is pulled
low for arming. Alternatively, you can
assign a two-position switch on the DC/DS transmitter to arm the
stabilisation and make the propellers spin. This switch does not
need to be assigned to any channel on the transmitter - the arming
command is sent separately as soon as you confirm the dialog box
that appears after activating the switch.
Dead Zone - dead zone parameters indicate the size of the area
around the center position of the controls, where the resulting stick
position in the given direction is considered zero.
6.5. Fail-Safe
Note: for the DS12 transmitter, the SW module have to be
installed for this function ("remote commands" SW module).
Fail-Safe – turns the Fail Safe function
on or off. If the function is disabled, no
pulses on the receiver outputs are
generated in case of signal loss. If this
function is enabled, the receiver
EN
41
To Next Page
Loading...
