COMPLEX RADIO CONTROL SYSTEM
Heading hold – determines how
strongly the model will hold its
orientation in the given direction in the
" H e a d i n g H o l d " m o d e . I n t h e
"Normal" mode, this parameter is not
reflected in any way. You can only test
the direction holding function, for
example, while hanging on a propeller,
or in knife edge flight.
For each Flight mode, you can set the
default gain (this multiplies the
stabilisation gain and the heading hold
ability in all axes). You can also specify
whether to use the gain tuning via
special dedicated channels (see
„Configuration - Channel Assignment
- Assign Additional Channels”).
3D Aerobatic Factor (Stick Priority) - determines how the
stabilisation gain decreases depending on how the control stick
moves from the center position. For instance, a 60% aileron stick
priority means that at maximum left or right, the aileron gain will be
reduced to 40% and the stick direct position will be applied from
60%.
4.1.2. Choice of flight modes
Depending on your preferences, choose which flight modes to use
during flight - a total of 5 modes are available, allowing you to
switch between three in flight (see Description of flight modes
section).
EN
14
To Next Page
