COMPLEX RADIO CONTROL SYSTEM
Fail-Safe - the output is moved to a position given by the
parameter "Value" at a speed given by "Speed" parameter.
If you use intelligent, ie. stabilised Fail-Safe mode, the specified
values of the outputs are used as input for stabilisation and are
processed.
now" command.
You can set the Fail-Safe positions either by editing each output
value separately or by simply moving the transmitter controls to
the required position and activating the "Set fail-safe position
Fail-Safe Delay – indicates the time interval from a moment the
receiver detects signal loss to when the fail-safe control throws are
initiated. After the expiration of this time, the receiver outputs will
transfer to preset defaults or will be turned off (according to
individual pin settings).
outputs can be configured individually with the following options:
Hold - the receiver repeats the last known values on its output.
Out OFF - the output pin is deactivated.
EN
42
To Next Page
Loading...
