COMPLEX RADIO CONTROL SYSTEM
the value in small steps to make the motors spin after arming.
Please make sure that the stabilisation gain tuning function has
been created on the transmitter and has been assigned to a free
channel (8-24). Stabilisation gain control knob or a three-way
stabilisation flight mode switch should be added in the
„Model/Functions Assignment” menu in your DC/DS transmitter.
Subsequently select this function for a free channel in the
„Model/Servo Assignment” menu. Now it is possible to start
the Quick Wizard in the receiver menu, where in step 6 this three-
position switch can be used.
3. Stabilisation gain tuning channels for individual axes cannot
be assigned.
We recommend enabling the "Throttle-PID Attenuation (TPA)"
function in the „Configuration/Advanced Properties” menu. Set
the "TPA breakpoint" to a value before the oscillations start to
appear (e.g. 50%) and increase the "TPA value" by 10%
increments.
2. When at full throttle, the multicopter oscillates quickly, but
when the throttle is in the middle, the flight is calm.
EN
50
To Next Page
Loading...
