COMPLEX RADIO CONTROL SYSTEM
„Configuration/Channel assignment menu /Gimbal channels”.
can configure the individual outputs for the gimbal servos either by
going through the wizard (step 7) or in the
Maximum pitch - specifies the angle at which the servo is tilted to
its maximum deflection. Set this value so that the image is stable
when moving the model and does not tilt up or down.
Gimbal Pitch - shows the channel assigned in the transmitter to tilt
the camera up and down. The same channel will be used on the
receiver side to output the given camera gimbal axis.
Camera Yaw (pan) - shows the assigned channel on the transmitter
to rotate the camera. The same channel will be used on the receiver
side to output the given camera gimbal axis.
Damping (dmp.) - damping factor in the rotation axis. The higher
the value, the longer the camera will stay in the original direction,
and it will take longer time for it to turn to the new direction. At
100% the gimbal will always try to keep the original orientation.
Maximum roll - specifies the angle at which the tilt servo is at its
maximum displacement. Set this value so that the image stays
stable when moving the model and does not tilt left or right.
Gimbal Roll - shows the channel assigned in the transmitter to tilt
the camera to the left and right. The same channel will be used on
the receiver side for the output of the given camera gimbal axis.
EN
32
To Next Page
Loading...
