COMPLEX RADIO CONTROL SYSTEM
11.Assign a channel for switching
stabilisation flight modes. For the
possibility of choosing three flight
modes of stabilisation, select one of
the three-position switches.
10. Carefully make the calibration of
the sticks, elevators and rudder
functions step by step according to
the instructions of the wizard. After
correct calibration, the values in the
Controller line have to be in the
range of -100/0/+100 in the neutral
and full positions of the controller of
the exact function.
Note: first add a three-position switch to your DC/DS transmitter
as a new function in the Model – Functions Assignment menu.
Then assign this option to a free channel in the Model – Servo
Assignment menu. Subsequently, this three-position switch can
be used here in the receiver setup wizard.
12. If you have selected the "Use
gimbal" option in the previous steps,
assign the individual channels to the
gimbal control. You can skip this point
and configure the camera gimbal later
in the „Configuration -> Channel
Assignment -> Gimbal channels”.
EN
12
To Next Page
