COMPLEX RADIO CONTROL SYSTEM
Camera control (roll, tilting/pitch, and pan/yaw) - output pins
assignment for a stabilised camera gimbal controlled by servos.
default, and conventional servo pulses or OneShot125 protocol can
be used for control.
Serial UDI12/16 - serial output suitable for connection of devices
with UDI support (Universal Data Interface, e.g. Vbar).
PPM Positive Output - standard PPM signal with positive logic of
the PPM data stream. The idle state of the line is logic 0.
EX Bus - digital bidirectional communication for all 24 channels
transmission, telemetry and communication data. This setting is
suitable for example in connection with a Central Box or other EX
Bus-capable device.
LED Strip - a LED strip composed of programmable LED chips can
be connected to the dedicated pin of the receiver.
PPM Input - for a given receiver port, the PPM input signal from
another receiver is expected. This option is suitable if you want to
use a backup receiver with a PPM output stream.
PPM Negative Output - standard PPM signal with inverse logic of
the PPM data stream. The idle state of the line is logic 1.
S.BUS - digital communication for transmission of max. 16
channels, does not transmit telemetry data. Suitable for connecting
devices supporting this communication to the Duplex system.
JETIBOX/Sensor EX - connection of telemetry sensor or JETIBOX.
EN
44
To Next Page
Loading...
