COMPLEX RADIO CONTROL SYSTEM
6. the transmitter will ask you for
activation and after confirmation
the receiver will start the process of
activating the vario module and the
altimeter
8. further vario settings are possible in
the transmitter menu "Menu/Sensor
timers/Vario”
7. after activation, the "Vario" item will
be displayed as enabled in the
"Info/Installed modules" menu of the
receiver
9. the current values of absolute and
relative altitude, atmospheric
pressure, vario and others are
automatically displayed in the
relevant places of the transmitter
menu. You can use this telemetry
data for the alarms, voice messages,
logic functions, etc.
55
5. turn on the receiver first and then the transmitter. In the
transmitter, go to "Menu/Model/Device explorer"
Note: during the entire activation process, do not have any sensor
connected to thee receiver and its power supply has to be stabl.
EN
xxxx-xxxx-xxxx-xxxx
To Next Page
Loading...
