APPENDIX
HOW TO INSERT AND REMOVE A CARD
This system has two card slots and can save the screen capture data (refer to Chapter 3.7) and user map data
(refer to Chapter 3.6) to the memory card.
Insert memory card according to the procedures below.
This system accept only CF (Compact Flash) card. And an adapter which converts to PC card is necessary.
The Compact Flash cards of the major manufacturers have been confirmed to work with this system. However,
some cards do not work. Given the large number of Compact Flash card manufacturers, it is not possible to
confirm the compatibility of all available products. The manufacturers of cards that have been confirmed to be
compatible are shown below. The use of these cards is recommended.
Manufacturer Storage Capacity
SanDisk 512MB / 1GB / 2GB / 4GB
Lexer Media 512MB / 1GB / 2GB
Transcend 2GB
HAGIWARA SYS-COM 4GB
IO DATA 512MB / 1GB / 2GB
BUFFALO 512MB / 1GB / 2GB
Note: The file formats of the memory card can be used FAT16 and FAT32. The other formats cannot be used.
Note: Keep a card horizontal when inserting it into a card slot. An inclined card causes a failure.
Adapter
CF card
To Next Page
Loading...
