JRC JMA-610 Series - Page 17

-xv -
3.3.3 SWITCH DAY/NIGHT MODE [DAY/NIGHT] ............................................ 3-7
3.3.4 ADJUST BRILLIANCE OF INFORMATION ON RADAR DISPLAY
(BRILLIANCE SETTING) ........................................................................ 3-8
3.3.5 ADJUST SOUND VOLUME (BUZZER VOLUME) .................................. 3-8
3.3.6 RESET ALARM BUZZER [ALARM ACK] ................................................ 3-9
3.3.7 SET DISPLAY COLOR ........................................................................... 3-9
3.4 BASIC OPERATIONS ........................................................................... 3-10
3.4.1 START TRANSMISSION [TX] ............................................................... 3-10
3.4.2 STOP TRANSMISSION [STBY] ............................................................ 3-10
3.4.3 CHANGE RANGE (OBSERVATION RANGE SCALE) [+RANGE-] ....... 3-10
3.4.4 TUNE ..................................................................................................... 3-11
3.4.5 CONTROL SENSITIVITY [GAIN] .......................................................... 3-12
3.4.6 SUPPRESS SEA CLUTTER [SEA] ....................................................... 3-12
3.4.7 SUPPRESS RAIN/SNOW CLUTTER [RAIN] ........................................ 3-13
3.4.8 INTERFERENCE REJECTIO [IR] ......................................................... 3-14
3.4.9 HIDE/DISPLAY RANGE RINGS [RANGGE RINGS] ............................. 3-14
3.4.10 HIDE SHIP’S HEADING LINE (HL OFF) .............................................. 3-15
3.5 GENERAL OPERATIONS ..................................................................... 3-16
3.5.1 MOVE CROSS CURSOR MARK BY TRACKBALL .............................. 3-16
3.5.2 USE EBLS (ELECTRONIC BEARING LINES) [EBL1/EBL2] ................ 3-16
3.5.3 USE VRMS (VARIABLE RANGE MARKERS) [VRM1/VRM2] .............. 3-18
3.5.4 USE P-LINES (PARALLEL INDEX LINES) [P-LINE] ............................. 3-19
3.5.5 MOVE OWN SHIP’S DISPLAY POSITION [OFF CENT] ...................... 3-20
3.5.6 DISPLAY OTHER SHIPS’ TRAILS [TRAILS] ........................................ 3-20
3.5.7 DISPLAY OWN VECTOR [OWN VECT] ............................................... 3-22
3.5.8 OWN MARK .......................................................................................... 3-23
3.5.9 TIME SETTING ..................................................................................... 3-25
3.5.10 CHANGE THE UNIT OF RATE OF TURN .......................................... 3-27
3.5.11 EXPANSION ......................................................................................... 3-27
3.5.12 STC CURVE ......................................................................................... 3-28
3.6 DISPLAY USER MAP ........................................................................... 3-29
3.6.1 CREATE USER MAP(MARK/LINE) ...................................................... 3-29
3.6.2 CORRECT POSITION ON USER MAP (SHIFT ). ................................ 3-32
3.6.3 CORRECT POSITION ON USER MAP (SHIFT CLEAR). ..................... 3-32
3.6.4 SET USER MAP DISPLAY (MARK DISPLAY SETTING) ..................... 3-33
3.6.5 OPERATE USER MAP FILE (FILE OPERATIONS) .............................. 3-43
3.7 SCREEN CAPTURE ............................................................................. 3-47
3.7.1 SCREEN CAPTURE SETTING (SELECT CARD SLOT). ..................... 3-47
3.7.2 SCREEN CAPTURE SETTING (SAVE FILE). ...................................... 3-47