To Next Page

To Previous Page



3-36

Setting the geodetic system for navigation data to be saved (Geodetic)

To create navigation information, set the geodetic system that is used with the connected

navigation equipment. When navigation information is loaded, the geodetic system used

when the navigation information was saved, is displayed. Make sure that the displayed

geodetic system is identical to the one used with the navigation equipment. If the two

geodetic systems are different, the positions of navigation information of the display will

be shifted. Therefore, it is important to set the geodetic system of the navigation

equipment.

Procedures 1 Press [MENU] key.

Select 8.Next and press [ENTER] key.

Select 4.NAV Information and press [ENTER] key.

Select 6.Next and press [ENTER] key.

Select 2.Geodetic and press [ENTER] key.

2 Enter the desired geodetic system number. (See the next list)

The geodetic system is determined.

Questions and Answers:

Need help?

Do you have a question about the JRC JMA-610 Series and is the answer not in the manual?

JRC JMA-610 Series Specifications

General