5-49
5.4.10 Setting of Alarm
In case of connecting with alarm monitor system, set to operate as follows within specification of the alarm
monitor system as follows.
Confirm the communication specification with the alarm monitor system when you set it.
・Setting of output cycle of watchman timer reset contact signal
・Setting of alarm volume
・Output setting of relay contact signal
・Output setting of ALR sentence
・Setting of Outside ACK Recive
Open the Alarm menu according to the following procedures.
5) Open the Serviceman Menu.
6) Left-click the Installation Menu > Alarm.
The Alarm menu will appear.
5.4.10.1 Setting of output cycle of watchman timer reset contact signal
The timer reset of the watchman timer reset alarm is set. (Default: 3sec)
Intarbal set to operate display unit contact signal is output.
1) Open the Alarm menu.
2) Set the Timer Reset.
5.4.10.2 Setting of Alarm Volume
The alarm volume limitation is set.
1) Open the Alarm menu.
2) Set the Sound Output Mode.
・On: Setting that does not limit volume.
・Off1: Setting the limit all volume except key click sound in minimums.
・Off2: Setting the limit all voluse except key click sound and lost alarm warning sound in
minimums.
To Next Page
Loading...
Need help?
General
