6-13
6.2 INSTALLATION of POWER CONTROL UNIT
Power control unit NQE-3167 is used when an antenna and a transmitter-receiver are installed at al
location away from the briges, such as aforemast.
By using NQE-3167 power control unit, the maximum length of the cable that connects between the
display unit and the antenna (transmitter-recever) can be extended up to 400 meters.
2Unit: Maximum length of the cable connecting between the 65m
Display Unit and the Scanner Unit
3Unit: Maximum length of the cable connecting between the 30m
Antenna and the transmitter-receiver:
Maximum length of the cable connecting between the 35m
Transmitter-receiver and the display unit:
(When power control unit (NQE-3167)is used)
Maximum length of the cable connecting between the 400m
Display unit and antenna (transmitter-receiver):
2Unit: Maximum length of the cable connecting between the 65m
Power control unit and the scanner Unit
3Unit: Maximum length of the cable connecting between the 30m
Scanner Unit and the transmitter-receiver:
Maximum length of the cable connecting between the 35m
Transmitter-receiver and the power control unit:
6.2.1 Connection with NKE-1125,NTG-3225,NKE-1130,NTG-3230
Use 14-core composite cable 2695110056 for the installation of those types of antennas.
For the procedures for processing the cable end, see Fig 5-14: Equipment cable end processing.
For the wiring procedures, see Section 6.2.8 Inter-board connection diagram of power control unit.