3-11
3.6 Connections with GYRO and Electormagnetic
LOG
The GYRO signal should be connected to TB302 of standart terminal board circuit
CQD-2121 in the display unit (processing unit).
Connect synchro-type GYROs to R1, S1, S2, S3, and R2, and connect step-type
GYROs to 1, 2, 3, and 5 (COMMON for 5).
Connect a gyro equipment or equivalent that provided a below turn rate, otherwise
the performance of signal process and target tracking decrese.
Standard craft 12°/sec
High speed craft 20°/sec
The pulse-type log signal should be connected to TB302 (P+, P-) of standard
terminal board circuit CQD-2121 locatied in display unit (processing unit). The
syncro-type log signal shoud be connected to (S1+, S1-) of TB302 as well.
To Next Page
Loading...
Need help?
General
