3-1
3. Installation of Display Unit
3.1 Installation of Display Unit
Setting the display unit
Determine the installation location of the display unit by considering following conditions:
(1) Consider and install the installation size to be specified at the outline drawing of in the place
for which it is possible to insert a cable from the installation and the base of the bolt.
(2) Do not place obstructions around the front side of the unit so that a user can eject a DVD/FD
and USB.
(3) To decrease an influence over the magnetic compass, separate from the compass by more
than 1.6m at least.
(4) Eliminating the interference on frequencies used for marine communications and navigation
due to operation of the radar. All cables of the radar are to be run away from the cable of radof
radio equipment. (ex. Radiotelephone, communications receiver and direction finder. Etc…)
Especially inter-wiring cables between scanner unit and display unit of the radar should not be
run parallel with the calbe of radio equipment.
(5) Install the monitor unit so that when the user is looking ahead, the lookout view is not
obscured.
(6) Away from spray of seawater or rainwater from windows or doors of bridge.
(7) Don't install near the equipment which generates the place, and the heat which gets the direct
sunlight.
(8) Establish a next-page, considering an equipped position to the reference.
When there are other equipment and a wall on either side, in the surface and the back, it is
convenient in maintenance, check when making wiring for the equipment be lax to the style
which it is possible to draw out in front of the processing part beforehand.