I d. Save
messages
Save one message
The
selected message can be saved.
Procedures
1)
Move cursor to the message to save.
2) Press the
8
key.
The sub screen appears.
3)
Select the
·sAVE
MENU", and press the IENlj key.
4)
Select the •[SELECT MSG]"
in
the sub screen
of
·sAvE
MAN
UN.
[Notes I
-Select
an item in the same procedure as ·d. Save
the message- 3)" (p.6-10) after the above
procedure.
5) The
•@"
mark
on
the saved message line shows the
message has saved
completely.
Save messages
at
the
same
time
The messages which are put the check mark can be saved
at the same time.
Procedures
1)
Continued from Procedure 5) of "c. Put a check
markR.
2) Select the
·sAVE
MENU", and the IENlj key.
In addition, when the following characters are
displayed,
It
means that the checked number is exceeded the
number which
can
be saved in the memory.
To
display to previous
screen,
select "[CANCEL]•.
[SELECT
MSG]
·~R~l~"A~O~]
[CANCEL]
RX1(518kHz) cannot be saved any more to the"""'""""'"''
~-~·
RX2 (490kHz)
101"11......--r"""""*r-r------...........,...,.....,...-rr~----~
~-~·RX3
(4209.5 kHz)
r-1:
RX1
and RX2
!!~~;=~
RX1
and RX3
...,r;]i'-"="~._..
RX2 and RX3
RX1, RX2 and RX3
In this case, messages still can be put a check,
however, the messages cannot be saved.
3)
Select the •[CHECK
MSGr.
and the IENlj key.
To
clear to all check marks, select ·[RESET CHECK]"
and press the
00
key.
l Notes I
- Select an item
in
the same procedure as "d. Save
the message- 3)" (p.6-10) after the above procedure
4)
The"§"
mark on the saved message line shows the message has saved completly.
6-17
To Next Page
Loading...
