– 107 –
* In the case the password has been set up and the key-lock has been enabled, the password input
screen is displayed when the mode key is pressed on the sewing screen. (Refer to the description
given below for the operation procedure.)
Once the correct password is input, input of the password is not required until the power is turned
OFF.
Be aware that, even if the password has been set, the mode screen can be displayed without input-
ting the password in the case the key-lock is disabled.
Password Key-lock Input of the password before
displaying the mode screen
Set up already Enabled Necessary
Set up already Disabled Unnecessary
1. Input the password on the password
input screen. Then, press
❺
.
(Refer to
"8-8-3.(3)
②
Setting up a
password" p.105
for how to input the
password.)
2. If the correct password is input, the
mode screen will be displayed.
3. If a wrong password is input, the error
screen will be displayed.
Press
❽
to reset the error and
return the error screen to the password
input screen.
<Password input screen>
❺
1. Open the control box. Place DIP switch
2 on the main body PCB in ON. Then,
turn the power ON.
2. After the password initialization com-
pletion message screen is displayed,
turn the power OFF.
3. Place DIP switch 2 back in OFF. When
the power is turned ON again, the sew-
ing machine starts up in the "password
is not set" state.
<Password initialization completion message screen>
* If you forget your password, you can return the password setup status to "not set" state. (Even if you
carry out the procedure described below, any data other than the password data will not be deleted.)
❽
To Next Page
Loading...
