JUKI FX-1R - I;O Control Board (40001943)

FX-1/FX-1R Maintenance Manual
13-4-8. I/O Control Board (40001943)
[Functions]
This board receives signals input from each sensor and outputs relevant control signals to other
boards.
This board also relays the cables to the MTC.
[Switch settings]
The jumper and DIP switches have already been set at delivery. However, check that they are set
as shown below before setting the I/O control board assembly in the control unit.
Jumper switches DIP switches
W3 (2P) → Open SW 1-1 → OFF
W5 (2P) → Open SW 1-2 → OFF
W6 (2P) → Open SW 1-3 → OFF
W7 (2P) → Short-circuit SW 1-4 → OFF
W8 (2P) → Short-circuit SW 1-5 → OFF
SW 1-6 → OFF
SW 1-7 → OFF
SW 1-8 → OFF
13-16
Rev. 2.00