JUMO DICON 401 - Manual Operating Mode

5 Operation
28
5.5.2 Manual operating mode
For start-up and testing, a setpoint, the states of the operating contacts and
the active parameter set can be input manually.
Operating level The settings can be made at the operating level, under the menu item “System
states”.
System state
OPERATNG ➔ SYSSTATE
Parameter Value/
selection
Description
Setpoint of
manual mode
➔ SETPOINT 0.
lower setpoint limit
… upper setpoint limit
Operating contact
1—8
➔
OPCNTCT1 ON
OFF
ON
OFF
Parameter set
➔
PARA.SET 1
1—2