1 Introduction
8
1.3 Typographical conventions
1.3.1 Warning signs
The signs for Danger and Warning are used
in this manual under the following conditions:
V
Danger This sign is used when there may be danger
to personnel if the instructions are disregard-
ed or not followed accurately.
*
Warning This sign is used when there may be damage
to equipment or data if the instructions are
disregarded or not followed accurately.
E
Warning This sign is used when special care must be
taken when handling components that are
sensitive to electrostatic discharges.
1.3.2 Note signs
)
Note This symbol is used when your attention is
drawn to a specific remark.
Ö
Reference This sign refers to additional information in
other manuals, chapters or sections.
H Action This sign refers to an action to be performed.
The individual steps are marked by this
asterisk, e. g.:
h Press I key
1.3.3 Presentation
E + I Key combination The depiction of keys together with a plus
sign means that first the E key has to be
pressed and held down, and then a further
key is pressed.
CONFIG 1 Dot-matrix display Texts and messages are visualised in the dot-
matrix display.