Juniper ACX5048 - Removing a Power Supply from an ACX5000 Router

Figure 50: Installing a Fan Module in a 2 U ACX5096
SEE ALSO
Cooling System and Airflow in an ACX5000 Router | 60
Field-Replaceable Units in an ACX5000 Router | 20
Management Panel of an ACX5000 Router | 47
Removing a Power Supply from an ACX5000 Router
The power supplies in an ACX5000 router are hot-removable and hot-insertable field-replaceable units
(FRUs): you can remove and replace them without powering off the router or disrupting routing functions.
Before you remove a power supply from a ACX5000 router, ensure that you have taken the necessary
precautions to prevent electrostatic discharge (ESD) damage (see “Prevention of Electrostatic Discharge
Damage” on page 196).
Ensure that you have the following parts and tools available to remove a power supply from a ACX5000
router:
•
ESD grounding strap
•
Antistatic bag or an antistatic mat
•
Phillips (+) screwdriver, number 2 (DC power supply)
CAUTION: Replace the power supply with a new power supply within 1 minute of
removal to prevent chassis overheating.
To remove a power supply from an ACX5000 router (see Figure 51 on page 138 and Figure 52 on page 138):
136