Table 33: RJ-45 Management Port Connector Pinouts for an ACX5000 Router (continued)
DescriptionSignalPin
Transmit/receive data pair 2TRP2–6
Transmit/receive data pair 4TRP4+7
Transmit/receive data pair 4TRP4–8
SEE ALSO
Management Port LEDs on an ACX5000 Router | 55
Console Port Connector Pinouts for an ACX5000 Router
The console port (labeled CON, C1, or CONSOLE) is an RS-232 serial interface that uses an RJ-45 connector
to connect to a console management device. The default baud rate for the console port is 9600 baud.
Table 34 on page 97 provides the pinout information for the RJ-45 console connector. An RJ-45 cable
and RJ-45 to DB-9 adapter are supplied with the ACX5000 router.
NOTE: If your laptop or PC does not have a DB-9 pin contact and you want to connect your
laptop or PC directly to an ACX5000 router, use a combination of the RJ-45 cable and RJ-45 to
DB-9 adapter supplied with the router and a USB to DB-9 plug adapter. You must provide the
USB to DB-9 plug adapter.
Table 34: Console Port Connector Pinouts for an ACX5000 Router
DescriptionSignalPin
Request to sendRTS Output1
Data terminal readyDTR Output2
Transmit dataTxD Output3
Signal groundSignal Ground4
97
To Next Page
Loading...
