Juniper ACX5048 - USB Port Specifications for an ACX5000 Router

Table 34: Console Port Connector Pinouts for an ACX5000 Router (continued)
DescriptionSignalPin
Signal groundSignal Ground5
Receive dataRxD Input6
Data carrier detectDCD Input7
Clear to sendCTS Input8
SEE ALSO
Connecting an ACX5000 Router to a Management Console | 120
USB Port Specifications for an ACX5000 Router
The following Juniper Networks USB flash drives have been tested and are officially supported for the
USB port in the ACX5000 routers:
•
RE-USB-1G-S—1-gigabyte (GB) USB flash drive
•
RE-USB-2G-S—2-GB USB flash drive
•
RE-USB-4G-S—4-GB USB flash drive
CAUTION: Any USB memory product not listed as supported for the ACX5000 routers
has not been tested by Juniper Networks. The use of any unsupported USB memory
product could expose your device to unpredictable behavior. Juniper Networks
Technical Assistance Center (JTAC) can provide only limited support for issues related
to unsupported hardware. We strongly recommend that you use only supported USB
flash drives.
CAUTION: Remove the USB flash drive before upgrading Junos OS or rebooting a
ACX5000 routers. Failure to do so could expose your device to unpredictable behavior.
98