Juniper ACX5048 - ACX5096 Router Hardware and CLI Terminology Mapping

Table 5: CLI Equivalents of Terms Used in Documentation for an ACX5048 Router (continued)
Additional Information
Item in
Documentation
Value (as
displayed in the
CLI)
Description (as
displayed in the
CLI)
Hardware
Item (as
displayed
in the CLI)
“Cooling System and Airflow
in an ACX5000 Router” on
page 60
Fann is a value in the
range of 0-4.
FanFan
Figure 3: ACX5048 Interface Port Mapping
g0008 0 9
1 2
3
3—1— 40 Gigabit Ethernet ports (6)Electrostatic Discharge (ESD) terminal
2—10 Gigabit Ethernet ports (48)
ACX5096 Router Hardware and CLI Terminology Mapping
Table 6 on page 24 describes the hardware terms used in an ACX5096 router documentation and the
corresponding terms used in the Junos OS command line interface (CLI). Figure 4 on page 26 shows the
port locations of the interfaces.
Table 6: CLI Equivalents of Terms Used in Documentation for an ACX5096 Router
Additional Information
Item in
Documentation
Value (as
displayed in the
CLI)
Description (as
displayed in the
CLI)
Hardware
Item (as
displayed
in the CLI)
“Chassis Physical
Specifications for an ACX5000
Router” on page 82
Router chassis–ACX5096Chassis
Interface Naming Conventions
Used in the Junos OS
Operational Commands
The router does not
have actual FPCs. In this
case, FPC refers to the
router itself.
Value of n is always
0.
Abbreviated name
of the Flexible PIC
Concentrator (FPC)
FPC (n)
24