Juniper ACX5048 - Management Port Leds on an ACX5000 Router

Table 8: Chassis Status LEDs on an ACX5000 Router (continued)
DescriptionStateColorName
The beacon feature is not enabled on
the router. This feature is enabled using
the request chassis beacon command.
OffUnlitID–Identification
The beacon feature is enabled on the
router. This feature is enabled using
the request chassis beacon command.
BlinkingBlue
SEE ALSO
show chassis alarms
request chassis beacon
Management Port LEDs on an ACX5000 Router
The management ports (labeled C0 for 10/100/1000 Base-T and C1 for 10/100/1000 Base-T and SFP
1000 Base-X connections) on an ACX5000 router have two LEDs that indicate link status and link activity
(see Figure 12 on page 56). The left LED indicates status; the right LED indicates link/activity.
55