Juniper ACX5048 - Router Ports

Figure 10: ACX5096 Router Port Panel
3—1— 40 Gigabit Ethernet ports (8)Electrostatic Discharge (ESD) terminal
2—10 Gigabit Ethernet ports (96)
This topic describes:
Router Ports
The ACX5096 ports, (0 through 95) support:
•
1 Gbps SFP transceivers
•
10 Gbps SFP+ transceivers
•
10 Gbps direct attach copper (DAC) cables
Ports 96 through 104 support:
•
40 Gbps QSFP+ transceivers
Additionally ports 96 and 100 support:
•
QSFP+ direct attach copper (DAC) cables
•
QSFP+ to SFP+ direct attach copper break out (DACBO) cables
•
QSFP+ to SFP+ fiber break out cables
All 96 of these ports can be used for SFP+ transceivers or SFP+ direct attach copper (DAC) cables. You
can use 1-Gigabit Ethernet SFP+, 10-Gigabit Ethernet SFP+ transceivers and SFP+ direct attach copper
cables in any access port.
CAUTION: Do not place a copper transceiver in an access port directly above or below
another copper transceiver. Internal damage to the access ports and router can occur.
We recommend either using the top port row exclusively, or bottom port row
exclusively, for copper transceivers.
52