•
Frequent plugging and unplugging of fiber-optic cables in and out of optical instruments
can damage the instruments, which are expensive to repair. Attach a short fiber
extension to the optical equipment. Any wear and tear due to frequent plugging and
unplugging is then absorbed by the short fiber extension, which is easier and less
expensive to replace than the instruments.
•
Keep fiber-optic cable connections clean. Microdeposits of oil and dust in the canal of
the transceiver or cable connector can cause loss of light, reduction in signal power,
and possibly intermittent problems with the optical connection.
•
To clean the transceiver canal, use an appropriate fiber-cleaning device such as
RIFOCS Fiber Optic Adaptor CleaningWands (part number 946). Follow the directions
in the cleaning kit you use.
•
After cleaning the transceiver, make sure that the connector tip of the fiber-optic
cable is clean. Use only an approved alcohol-free fiber-optic cable cleaning kit such
as the Opptex Cletop-S
®
Fiber Cleaner. Follow the directions in the cleaning kit you
use.
Related
Documentation
• Connecting a Fiber-Optic Cable on page 159
• Laser and LED Safety Guidelines and Warnings on page 261
Copyright © 2017, Juniper Networks, Inc.202
EX4200 Switch Hardware Guide
To Next Page
Loading...
Need help?
General