VII User Manual | Pedelec Groove 9
5 Control panel
1
2
1 Button for power assist level
2 On/O switch
3 Power-assist mode display
4 Battery charge state indicator
3
4
The control panel on the handlebar has two or three but-
tons (depending on the model) and two rows of LED indi-
cators. The button used to control the level of assistance
is located on the le-hand side of the control panel.
To the right at the bottom you can see the LED display bar
which indicates the level of assistance which has been
activated and the current battery charge state.
The POWER button is located above the LEDs.
Press this button to switch the control panel on and o.
On/O button
If the model features pushing assistance, the switch for
this will be on the underside of the control panel.
Button for pushing assistance
5.1 On/O button
Press the POWER button to switch the control panel on
and o.
Aer it has been switched on, the system is always in the
medium power-assist mode SPORT.
5.2 Switches for power-assist level
You can speci the power assist level via the Mode
button.
Buttons for power assist level
Each time you press the Mode button the power assist
changes by one level.
Each time you press the Mode button, the assistance
changes by one level om ECO through to the highest level
POWER.
If you require less assistance, press the Mode button until
the level of assistance moves om the highest back to the
lowest level.
To Next Page
Loading...
Need help?
General
