Original User Manual | Pedelec Impulse 2.0 15
6 Charger
If used incorrectly, the device may be damaged or
inict injuries.
• Only use the charger in dry rooms.
• Only place the charger in a secure stable position
on a suitable surface.
• Do not cover the charger or place any objects on
it as otherwise it could overheat and catch re.
› Do not use other chargers. Only charge the bat-
tery using the charger provided, or a charger
approved by us.
› Read the type plates on the charger before using
it for the rst time.
You can charge your Pedelec Impulse 2.0 directly via a
charging socket in the battery. The battery can remain on
the Pedelec whilst the charging operation is in progress.
Charging the battery
SEAT TUBE BATTERY
Alternatively, you can take the battery out of its holder
and charge it elsewhere. This is recommended if it is cold
outside, in order to charge the battery in a warmer room.
The battery can be charged at temperatures between 0°C
and 45°C.
Battery in the docking station
SEAT TUBE BATTERY
If a charging fault occurs, the LED (where present)
in the charger ashes red. In this case, the charging
current is too high. Disconnect the battery om the
charger and then connect it again. If the error mes-
sage still appears, the battery and charger must be
checked by a specialist cycle shop.
7 Control panel and display
The Pedelec Impulse 2.0 can be controlled via two ele-
ments. The control panel can be found on the handlebar
grip; the display is located in the middle of the handlebar.
7.1 Control panel
1 button
2 button
3 button
4 button
1
2
3
4
Press the button to switch the system on and o. But-
tons 2 to 4 have dierent nctions depending on the item
of the settings menu in which you are located.
To Next Page
Loading...
Need help?
General
