Original User Manual | Pedelec Impulse 2.0 9
4 Quick start
1. Charge the battery completely before riding for the
rst time. Charge temperature: 0°C to 45°C.
Charging the battery
SEAT TUBE BATTERY
2. Remove the cover om the charging socket.
3. Connect the plug of the charger to the battery.
Charging the battery
DOWN TUBE BATTERY SEAT TUBE BATTERY
4. Insert the mains plug for the charger into the socket.
› You must charge the battery completely before
using it for the rst time. Depending on the
manufacturer of the cells, the batteries will have
a charge state of between 30 and 50%.
› You can also remove the battery om your
Pedelec and charge it elsewhere. For more in-
formation on this subject, refer to ➠
Chapter 5
“Battery”.
5. Once all of the battery LEDs have gone out, the battery
is lly charged. Pull the plug of the charger out of the
charging socket and take the mains plug of the charger
out of the socket.
6. a) Down tube battery: If you removed the battery for
charging, replace it in the holder om the ont/above.
At the same time, the key must be in the lock and must
be turned anticlockwise. Press the battery down into
the holder until the locking mechanism engages.
6. b) Seat tube battery: If you removed the battery for
charging, reinsert the battery into the holder on the
Pedelec om the le-hand side. Tilt the battery out-
wards at an angle of roughly 45° as you do so. Move
the battery into the upright position until the locking
mechanism engages.
Installing the battery
DOWN TUBE BATTERY SEAT TUBE BATTERY
7. Now turn the key clockwise and remove it. The battery
is now locked in place.
Locking the battery
DOWN TUBE BATTERY SEAT TUBE BATTERY
8. Make sure that the battery is securely positioned and
that the key is no longer in the lock.
9. Press the button on the control panel to switch on
the drive system.
10. a) Pedelec without backpedal nction: Aer the wel-
come screen, the display shows the power-assist mode
that was last set. Press the
/ buttons to select the
level of assistance: ECO (low), SPORT (medium),
POWER (high) or no assistance. Pressing once changes
the level of assistance by one level. This works both
ways, depending on which of the buttons you press.
10. b) Pedelec with backpedal nction: Aer the welcome
screen, the display shows “Please move the pedals” |
“PEDAL”. This instruction will disappear as soon as
you start riding. Press the
/ buttons to select the
level of assistance: ECO (low), SPORT (medium),
To Next Page
Loading...
Need help?
General
