Instructions for use ELECTROmatic TM and TMM/TMC
6 Operation | 6.5 ENDO Mode
68 / 90
Deactivating file from file sequence
If the user does not need all 10 files of the file sequence for treatment, he or
she can deactivate files in the sequence.
▶ Open the file editor, then tap file sequence "SEQUENCE 1" to display the se-
lection list of the file sequences.
▶ Tap the "Pen" control element to edit the sequence.
ð The display shows file sequence "SEQUENCE 1" in editing mode.
▶ Select the file to be deactivated.
▶ Tap the second column "File system" and shift the column vertically until
the symbol for deactivated "-" is selected.
▶ Tap the "Back" control element to terminate the processing of file se-
quences.
ð The set data are saved.
If a file is deactivated, it is shown without a colour marking, presently file "E1".
Since a deactivated file cannot be selected, the data of the selected file "E0" are
displayed in the figure below.
To Next Page
Loading...
