Instructions for use ELECTROmatic TM and TMM/TMC
6 Operation | 6.5 ENDO Mode
▶ Open the file editor, then tap file sequence "SEQUENCE 1" to display the se-
lection list of the file sequences.
▶ Tap the "Pen" control element to edit the sequence.
ð The display shows file sequence "SEQUENCE 1" in editing mode.
▶ In order to define user-defined files, tap the second column "File system"
and shift the column vertically until "FILE RECI R" or "FILE RECI L" are
shown with a blue background.
▶ Tap the "Pen" control element again to edit the file name.
▶ Tap the "Back" control element to terminate the processing of file se-
quences.
ð The set data are saved.
If a user-defined file with reciprocal motion is selected, the display may show
the following:
67 / 90
To Next Page
Loading...
Need help?
General
