KEB COMBIVERT F4-F - Function of the Digital Outputs; Relay Outputs (continued)

11
ANTRIEBSTECHNIK
1
111
21.06.99KEB COMBIVERT F4-F
Name: Basis
1
Introduction
General
© KEB Antriebstechnik, 1999
All Rights reserved
Chapter Section PageDate
6.12 CP-Parameter Definition .................................................................. 6.12.3
6.12.1 Survey ............................................................................... 6.12.3
6.12.2 Assignment of CP-Parameter ........................................... 6.12.4
6.12.3 Start Parameter (ud.2, ud.3).............................................. 6.12.4
6.12.4 Example ............................................................................ 6.12.5
6.12.5 Used Parameters............................................................... 6.12.5
7. Start-up............................................................................................................ 7.1.3
7.1 Preparatory Measures ....................................................................... 7.1.3
7.1.1 After unpacking the Goods .................................................. 7.1.3
7.1.2 Installation and Connection ................................................. 7.1.3
7.1.3 Checklist prior to Start-up.................................................... 7.1.4
7.2 Initial Start-up ..................................................................................... 7.2.3
7.2.1 Start-up (controlled) ............................................................ 7.2.3
7.2.2 Start-up (closed-loop) .......................................................... 7.2.4
8. Special Operation ....................................................................................8.1.2
9. Error Assistance...................................................................................... 9.1.3
9.1 Troubleshooting ................................................................................. 9.1.3
9.1.1 General ............................................................................... 9.1.3
9.1.2 Error Messages and their Cause......................................... 9.1.3
10. Project Planning ....................................................................................10.1.3
10.1 General Design ................................................................................. 10.1.3
10.1.1 Control Cabinet Design Calculation .................................. 10.1.3
10.1.2 Design of Braking Resistors .............................................. 10.1.4
11. Networks ................................................................................................ 11.1.3
11.1 Network Components ...................................................................... 11.1.3
11.1.1 Available Hardware............................................................ 11.1.3
11.1.2 RS232-Cable PC/Inverter.................................................. 11.1.3
11.1.3 Interface- and Bus-Operator .............................................. 11.1.4
11.1.4 Optical Fibre BUS.............................................................. 11.1.5
11.1.5 InterBus Loop-Operator..................................................... 11.1.9
11.2. Bus-/DRIVECOM-Parameter ............................................................ 11.2.3
11.2.1 Adjustment of Inverter Address (ud.6)............................... 11.2.3
11.2.2 Baud Rate (ud.7) ............................................................... 11.2.3
11.2.3 Watchdog-Time (ud.8) ....................................................... 11.2.3
11.2.4 Used parameter................................................................. 11.2.4
12. Applications ........................................................................................... 12.1.2
13. Annex .....................................................................................................13.1.3
13.1 Search and Find ............................................................................... 13.1.3
13.1.1 Index.................................................................................. 13.1.3
13.1.2 Term Definition .................................................................. 13.1.9
13.1.3 KEB- Worldwide .............................................................. 13.1.11
13.1.4 Domestic Representations .............................................. 13.1.12
13.1.5 Notes ............................................................................... 13.1.13