KEB combivert R6-S User Manual

3. Introduction
3.1 Preface
The described hard- and software are developments of the KEB Automation KG. The en-
closed documents correspond to the conditions valid at printing. Misprint, mistakes and tech-
nical changes reserved.
The manual must be made accessible for each user. Before working with the unit the user
must become familiar with it. This especially applies to the knowledge and observance of the
followingsafetyandwarningindications.Theusedpictogramshavefollowingsignicance:
Danger
Is used, if life or health of the user is in danger or if
substantial damage to property can occur.
Warning
Caution
Attention
Is used, if a measure is necessary for the safe and
trouble-free operation.
Essential
discharge time
Information
Isused,ifameasuresimpliesthehandlingoropera-
tion of the unit.
Help
Tip
Non-observance of the safety instructions leads to the loss of any liability claims. This list is
not exhaustive.
3.2 Product description
This instruction manual describes the power supply and regenerative unit KEB COMBIVERT
R6-S. The COMBIVERT R6-S has the following features.
The supply unit
• converts a three-phase input voltage into DC voltage.
• supplies single KEB frequency inverter or via DC interconnection.
• can be parallel connected if higher power supply is required.
• increases the stability of the DC link voltage in the DC interconnection.
The regenerative unit
• refeeds excess energy from regenerative operation into the supply system.
• reduces the energy demand.
• reduces the heat emission.
• is environmentally friendly and space-saving.
• replaces braking resistor and braking transistor.
• is cost-saving.
GB - 57
Introduction

KEB combivert R6-S Specifications

General

Brand	KEB
Model	combivert R6-S
Category	Power Supply
Language	English