X5 FastMig
Operating manual - EN
Tip: Additional X5 Wire Feeder 300 strain relief fixing (M6x16 screw), optional:
7. X5 Wire Feeder 300:Close and lock the cable cabinet door.
When connecting the cables to the wire feeder, route the cables neatly so that the cable cabinet door closes properly.
The interconnection cable heats up during welding. The wire feeder's cable cabinet door must be kept closed when
welding, and the cables must be handled with caution if the cabinet door is opened right after welding.
© Kemppi
42
1920960 / 2144
To Next Page
Loading...
Need help?
General
