Kemppi X5 FastMig - Page 61

X5 FastMig
Operating manual - EN
7. Select the feed rolls according to the tables below.
Wire feed rolls, plastic
Filler wire material Feed roll profile
Filler wire dia-
meter (mm)
Feed roll iden-
tification
Drive roll code Pressure roll code
Fe, Ss, Cu (Al, Mc,
Fc)
V-groove 0.6 W001045 W001046
0.8−0.9 W001047 W001048
1.0 W000675 W000676
1.2 W000960 W000961
1.4 W001049 W001050
1.6 W001051 W001052
2.0 W001053 W001054
2.4 W001055 W001056
Fc, Mc (Fe)
V-groove, knurled 1.0 W001057 W001058
1.2 W001059 W001060
1.4−1.6 W001061 W001062
2.0 W001063 W001064
2.4 W001065 W001066
Al (Fc, Mc, Ss, Fe,
Cu)
U-groove 1.0 W001067 W001068
1.2 W001069 W001070
1.4 W008974 W008975
1.6 W001071 W001072
(The materials mentioned inside brackets refer to secondary suitability.)
Wire feed rolls, metal
Filler wire material Feed roll profile
Filler wire diameter
(mm)
Drive roll code Pressure roll code
Fe, Ss (Mc, Fc)
V-groove 0.8−0.9 W006074 W006075
1.0 W006076 W006077
1.2 W004754 W004753
1.6 W006078 W006079
Fc, Mc (Fe)
V-groove, knurled 1.0 W006080 W006081
1.2 W006082 W006083
1.4−1.6 W006084 W006085
2.0 W006086 W006087
© Kemppi
61
1920960 / 2144