X5 FastMig
Operating manual - EN
(Fc, Mc, Ss, Fe)
U-groove 1.0 W006088 W006089
1.2 W006090 W006091
1.6 W006092 W006093
(The materials mentioned inside brackets refer to secondary suitability.)
8. Follow the previous steps in reverse to install the wire feed rolls. Align the cut on the drive rolls' bottom with the pin
on the drive shaft.
9. Reattach the mounting caps and mounting pins to lock the drive and pressure rolls into their places.
10. Close the locking arms and lower the pressure handles on the feed rolls. Refer to "Installing and changing wire (X5
WF 300)" on page53 and "Installing and changing wire (X5 WF 200)" on page48 for more information on the wire
installation.
11. Close the wire feeder cabinet.
© Kemppi
62
1920960 / 2144
To Next Page
Loading...
Need help?
General
