DISPlay:TEXT:CLEar
Clears the text displayed on the front panel.
Parameter Typical return
(none) (none)
Clears the text message displayed on the front panel: DISP:TEXT:CLE
– Clearing a text message does not override the display state (DISPlay:STATe command). If the display was disabled
prior to clearing the text message, the display will remain disabled.
– The front panel display is automatically cleared when power is cycled, or after a Factory Reset (*RST command).
116
Keysight DAQ970A/DAQ973A Programming Guide
2 SCPI Programming
To Next Page
Loading...
