Keysight Technologies DAQ970A - Page 140

FORMat:READing:ALARm {OFF|ON}
FORMat:READing:ALARm?
Enables (On) or disables (Off) the inclusion of alarm information in the reading format.
Parameter Typical return
{OFF|ON}
Default: OFF
0 (OFF) or 1 (ON)
Enables the inclusion of alarm information in the reading format:FORM:READ:ALAR ON
– The alarm setting will be disabled (Off) after a Factory Reset (*RST command).
FORMat:READing:CHANnel {OFF|ON}
FORMat:READing:CHANnel?
Enables (On) or disables (Off) the inclusion of channel number information in the reading format.
Parameter Typical return
{OFF|ON}
Default: OFF
0 (OFF) or 1 (ON)
Enables the inclusion of channel number information in the reading format:FORM:READ:CHAN ON
– The channel setting will be disabled (Off) after a Factory Reset (*RST command).
FORMat:READing:TIME {OFF|ON}
FORMat:READing:TIME?
Enables (On) or disables (Off) the inclusion of a time stamp in the reading format.
Parameter Typical return
{OFF|ON}
Default: OFF
0 (OFF) or 1 (ON)
Enables the inclusion of a time stamp in the reading format:FORM:READ:TIME ON
– The time stamp setting will be disabled (Off) after a Factory Reset (*RST command).
– If enabled, the time stamp information is shown either in absolute time or relative time as set by the
FORMat:READing:TIME:TYPE command.
140
Keysight DAQ970A/DAQ973A Programming Guide
2 SCPI Programming