Keysight Technologies DAQ970A - Page 172

MEASure:STRain:{FULL|HALF}:POISson? [{<gage_factor> | MIN | MAX | DEF},
[{<poisson_ratio> | MIN | MAX | DEF}, [{<range> | MIN | MAX | DEF},
[{<resolution> | MIN | MAX | DEF},]]]]] (@<ch_list>)
Only supported on DAQM900A, DAQM901A, DAQM902A, and DAQM908A multiplexer modules.
Resets all measurement parameters on the specified channels to their default values. Then, configures the channels
for full and half poisson bridge strain gage measurements and immediately sweeps through the specified channels
one time (independent of the present scan list). The results are sent directly to reading memory and the instrument's
output buffer. This command redefines the scan list.
Parameter Typical return
<gage_factor> = Any numeric value between 0.5 and 5
Default = 2
(none)
<poisson_ratio> = Any numeric value between -0.9999 and +0.5
Default = 0.3
<range> = {Auto | 100 mV | 1V | 10 V | 100V | 300V}
Default = AUTO
<resolution> = 1 PLC (0.000003 x Range)
MEASure:STRain:FULL:BENDing:POISson? [{<gage_factor> | MIN | MAX | DEF},
[{<poisson_ratio> | MIN | MAX | DEF}, [{<range> | MIN | MAX | DEF},
[{<resolution> | MIN | MAX | DEF},]]]]] (@<ch_list>)
Only supported on DAQM900A, DAQM901A, DAQM902A, and DAQM908A multiplexer modules.
Resets all measurement parameters on the specified channels to their default values. Then, configures the channels
for full bending poisson bridge strain gage measurements and immediately sweeps through the specified channels
one time (independent of the present scan list). The results are sent directly to reading memory and the instrument's
output buffer. This command redefines the scan list.
Parameter Typical return
<gage_factor> = Any numeric value between 0.5 and 5
Default = 2
(none)
<poisson_ratio> = Any numeric value between -0.9999 and +0.5
Default = 0.3
<range> = {Auto | 100 mV | 1V | 10 V | 100V | 300V}
Default = AUTO
<resolution> = 1 PLC (0.000003 x Range)
172
Keysight DAQ970A/DAQ973A Programming Guide
2 SCPI Programming