[SENSe:]STRain:UNSTrained:IMMediate [(@<ch_list>)]
This command immediately measures and stores the bridge offset voltages on the specified channel.
Parameter Typical return
<voltage> = Any numeric value between 1 to 12 V.
Default = 5.0
None
– You can measure and specify the offset manually for each channel, or you can use the
SENSe:STRAin:UNStrained:IMMediate command to automatically measure and store the offset for each chan-
nel.
Keysight DAQ970A/DAQ973A Programming Guide 255
2 SCPI Programming
To Next Page
Loading...
