TRIGger:SLOPe {POSitive | NEGative}
TRIGger:SLOPe?
Sets whether the instrument uses the rising edge (POS) or the falling edge (NEG) of the trigger signal on the rear-
panel Ext Trig BNC connector when external triggering is selected; or the rising or falling edge of the input signal
when level triggering is selected.
Parameter Typical return
{POSitive | NEGative}
Default: NEG
POS or NEG
Use rising edge (POS) of the trigger signal: TRIG:SLOP POS
– A Factory Reset (*RST command) resets the slope to the default negative rising edge.
Keysight DAQ970A/DAQ973A Programming Guide 341
2 SCPI Programming
To Next Page
Loading...
