TRIGger3:SLOPe {POSitive | NEGative}, (@<ch_list>)
TRIGger3:SLOPe? (@<ch_list>)
Sets the trigger slope on the specified channels.
These SCPIs are supported on the DAQM909A Digitizer module only.
Parameter Typical return
{POSitive | NEGative}
Default: NEG
POS or NEG
Use rising edge (POS) of the trigger signal for Digitizer channel 201:
TRIG3:SLOP POS,(@201)
– A Factory Reset (*RST command) resets the slope to the default negative rising edge.
Keysight DAQ970A/DAQ973A Programming Guide 347
2 SCPI Programming
To Next Page
Loading...
