E8257D/67D, E8663D PSG Signal Generators Service Guide 383
Assembly Replacement
A41 Flash Drive Door Assembly
A41 Flash Drive Door Assembly
Tools Required
— T–10 driver
—Standard Screwdriver
Removal Procedure
Refer to Figure 3-69 for this procedure.
1. Disconnect the power cord.
2. Using the standard screwdriver, unlock the door latch screw by rotating
counter–clockwise.
3. Remove the flash card (if applicable).
4. Using the T–10 driver, remove the two lower screws (1) that attach the
A41 door assembly to the rear panel.
Note: The screws act as retainers to keep the hinge pins from sliding out.
Replacement Procedure
1. Reverse the order of the removal procedure.
2. Torque all T–10 screws to 9 in–lbs.
3. Perform the post–repair adjustments and performance tests that pertain
to this removal procedure.
To Next Page
Loading...
